![]() Back at the terminal, create the directory with: sudo mkdir /home/share Next, we’re must create a directory to house the shares. Next, at the bottom of this file, we’re going to create the new public share with the following: To make sure Samba is only listening to that interface locate the below line: bind interfaces only = yesĬhange that line to: bind interfaces only = yes Locate the line: interfaces = 127.0.0.0/8 eth0Ĭhange that to: interfaces = 127.0.0.0/8 IFACE Open the Samba configuration file with: sudo nano /etc/samba/smb.conf Locate the NIC associated with your LAN address, which will be something like ens5. Start and enable the Samba service with: sudo systemctl enable -now smbdīefore we configure Samba, let’s find out what our LAN network interface is with the command: ip a Log into your Linux server and issue the command: sudo apt-get install samba -y The first thing we’ll do is install Samba. If you’re using a different distribution, you’ll need to alter the installation command accordingly. I’ll be demonstrating on Ubuntu Server 20.04. To make this work, you’ll need a Linux server and a user with sudo privileges. SEE: Hiring Kit: Network Engineer (TechRepublic Premium) What you’ll need Open source: Must-read coverageĦ Best Linux project management software in 2023Ħ best open-source kanban boards for managing projects in 2023Ħ Best Free Alternatives to Microsoft Word (2023 Update) But what if you sometimes have guests that pop up on your LAN (say, customers, clients, or temp employees)? Should that be the case, you might need to make a password-less share or two accessible to those guests or temps. Those shares are probably password protected (as they should be) to prevent unwanted people from gaining access to the data within. Is winbind running? If your server is not a domain member or a domain controller this may cause a bit of confusion while running stand-alone servers do not need this service.If you have multiple users on your LAN, chances are pretty good those users need easy access to file shares.Do you have an entry for client use spnego = no? (You may need yes instead when connecting with newer Windows clients).Do you have an entry for client signing = no? (You may need yes instead when connecting with newer Windows clients).What is the security = setting currently at in /etc/samba/smb.conf? If your Samba server is a member of a domain it should probably be security = ads if your Samba server is stand-alone it should probably be either security = user or security = share. ![]() While not necessary, it will help with authentication.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |